Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Figure 402: Routing cables
Ê Run the SAS and power cables through the cable clamps (see arrows) as
shown.

12.2.6 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
TX300 S7 / RX350 S7
379.
104.
"Mounting the side cover" on page 114
Upgrade and Maintenance Manual
Accessible drives
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
(tower
615