Removing The Modular Lan Controller - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê Remove all external cables from the expansion card to be replaced.
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Remove the air duct as described in section
on page 92.
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 887.
9.3.3.3

Removing the Modular LAN controller

Ê If applicable, remove SFP+ transceiver modules from the Modular LAN
controller to be removed, as described in section
transceiver modules" on page
Ê Remove the defective Modular LAN controller as described in section
"Removing the Modular LAN controller" on page
Ê If the slot bracket on the defective Modular LAN controller is to be reused,
remove it from the board as described in section
LAN controller" on page
TX300 S7 / RX350 S7
60.
67.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
"Onboard indicators and controls" on
528.
421.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Locating the defective
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
"Replacing SFP+
431.
"Preparing the Modular
"Shutting down the
72.
(tower
439