Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 680

Accessible drives
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to remove
accessible drive dummy covers (see section
drive dummy covers" on page
already installed in the server and will be removed in order to install
a slimline ODD or LSD module, skip this step.
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
Ê If the HDD extension box is already installed in the server, disconnect all
cables from the HDD backplane and remove the extension box as described
in section "Removing the 4x 3.5-inch HDD extension box" on page
680
75.
378.
Upgrade and Maintenance Manual
"Removing accessible
602). If the HDD extension box is
"Removing the system air duct"
"Removing the
331.
TX300 S7 / RX350 S7