Removing The Defective Gpgpu Card; Installing The New Gpgpu Card; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.4.3.3

Removing the defective GPGPU card

Ê Remove the defective GPGPU card as described in section
GPGPU card" on page
9.4.3.4

Installing the new GPGPU card

Ê Install the new expansion card as described in section
card" on page
9.4.3.5

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page
Ê After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
474
462.
443.
"Mounting the side cover" on page 114
125.
Upgrade and Maintenance Manual
"Installing the system air duct"
122.
"Connecting the server to
150.
156.
"Removing a
"Installing a GPGPU
"Mounting the top cover"
124.
151.
"Enabling SVOM
"Enabling
TX300 S7 / RX350 S7
(tower
154.