Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 342

Hard disk drives / solid state drives
Ê Hold the accessible drive filler cover by its two handle recesses and pull it
out of the desired installation bays.
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Removing accessible drive covers
Figure 213: Removing an accessible drive covers
I
Removing accessible drive covers is illustrated by the example of the
tower server. In case of the rack front cover, the procedure is identical.
Ê Turn the front cover face down.
Ê Press in on the lugs on either side of the drive cover.
Ê Fold up (1) and remove the desired accessible drive covers (2).
342 Upgrade and Maintenance Manual
TX300 S7 / RX350 S7