Ê Close the side / top cover as described in section
on page 107
(rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section
"Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê Verify if your backup software solution requires additional configuration after
installing, removing or replacing an accessible drive as described in section
"Verifying and configuring the backup software solution" on page
12.5
Slimline ODD and LSD in Multibay box
12.5.1 Installing the slimline ODD or LSD
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.5.1.1 Required tools
Preliminary and concluding steps: tool-less
●
Installing a slimline ODD or LSD:
●
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
TX300 S7 / RX350 S7
"Mounting the side cover" on page 114
125.
Upgrade and Maintenance Manual
Accessible drives
"Mounting the top cover"
124.
122.
"Connecting the server to
(tower
147.
627