Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 141

Ê Enter BIOS recovery mode using the onboard jumpers.
I
For detailed information on jumper settings, refer to section
settings" on page
Ê Close the side / top cover as described in section
page 104.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section
server to the mains" on page
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V
CAUTION!
Do not interrupt the BIOS recovery process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side / top cover as described in section
page 75.
Ê Disable BIOS recovery mode using the onboard jumpers:
I
For detailed information on jumper settings, refer to section
settings" on page
Ê Close the side / top cover as described in section
page 104.
TX300 S7 / RX350 S7
886.
125.
886.
Upgrade and Maintenance Manual
Basic software procedures
"Closing the server" on
"Connecting the
"Opening the server" on
"Closing the server" on
"Onboard
"Onboard
141