Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

10.4.5 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê If available, update the system board BIOS to the latest version as described
in section "Updating or recovering the system board BIOS and iRMC" on
page 139.
Ê Enable boot watchdog functionality as described in section
boot watchdog functionality" on page
Ê Enable the replaced memory module(s) as described in section
replaced components in the system BIOS" on page
Ê Verify if the memory mode has been restored to its original state as
described in section
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX300 S7 / RX350 S7
"Mounting the side cover" on page 114
125.
"Verifying the memory mode" on page
156.
Upgrade and Maintenance Manual
"Installing the system air duct"
"Mounting the top cover"
124.
122.
"Connecting the server to
150.
151.
Main memory
(tower
"Enabling SVOM
"Enabling
151.
"Enabling
547