Expansion cards and backup units
9.6.5.3
Removing the FBU holder from the chassis
Figure 329: Removing the FBU holder from the chassis
Ê Carefully disconnect the FBU cable from the RAID controller.
Ê Remove the FBU cable from the cable guide.
Ê Lift up the locking handle on the FBU holder (1, see close-up) while sliding
the FBU holder towards the server front as far as it will go (2).
I
After that, the fixation bolts on the chassis floor will rest in the wide
ends of the keyhole slots on the holder.
Ê Lift the FBU holder out of the chassis.
510
Upgrade and Maintenance Manual
TX300 S7 / RX350 S7