Replacing The Sas Raid Controller; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
9.5.3

Replacing the SAS RAID controller

Upgrade and Repair Units (URU)
Average hardware task duration: 10 minutes
Average software task duration: 5 minutes
9.5.3.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the SAS RAID controller: tool-less
●
– Phillips PH2 / (+) No. 2 screw driver
Mounting slot brackets:
●
– Phillips PH2 / (+) No. 2 screw driver
9.5.3.2

Preliminary steps

Before replacing an expansion card, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Locate the defective server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
484
156.
133.
60.
67.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
134.
"Locating the defective
"Shutting down the
TX300 S7 / RX350 S7
"Enabling