Converting a tower server to a rack server
15.7
Removing glider feet
Figure 564: Removing glider feet
Ê Using a slotted screw driver, slightly pry up on each glider foot until it
detaches.
Ê Bring the server back to its horizontal position.
I
At least two people are needed to turn over a fully equipped server.
Remove hard disk drives and power supply modules in order to
facilitate the task.
15.8
Preparing the intrusion switch
Ê Remove the intrusion switch module as described in section
intrusion switch cable" on page
Ê Attach a rubber bumper (C26192-Y26-C43) to the front intrusion switch and
reinstall the intrusion switch module as described in section
intrusion switch cable" on page
842
868.
871.
Upgrade and Maintenance Manual
"Removing the
"Installing the
TX300 S7 / RX350 S7