Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 643

Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
I
The front cover only needs to be removed in order to install
accessible drive dummy covers (see section
drive dummy covers" on page
after removing the slimline ODD or LSD module, skip this step.
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
TX300 S7 / RX350 S7
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
75.
378.
Upgrade and Maintenance Manual
"Disconnecting the server
73.
"Removing the top cover"
"Installing accessible
622). If the Multibay will be reinstalled
"Removing the system air duct"
Accessible drives
72.
(tower
"Removing the
643