Only applicable for removing intact HDD modules:
Ê Before removing a non-defective HDD module, put the drive into "Offline"
mode using your RAID configuration software.
I
For further information, please refer to the "ServerView Suite RAID
Management" user guide, available online at
(http://jp.fujitsu.com/platform/server/primergy/manual/
market) or from the ServerView Suite DVD 2 supplied with your
PRIMERGY server.
7.3.8.3
Removing a 3.5-inch HDD module
Ê Remove the HDD module to be replaced from the server as described in
section
"Removing a 3.5-inch HDD module" on page
7.3.8.4
Installing a 3.5-inch HDD module
Ê Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page
7.3.8.5
Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section
"Installing accessible drive and HDD bay covers" on page
Ê Please observe the notes on RAID rebuild in section
array rebuild" on page
TX300 S7 / RX350 S7
157.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
http://manuals.ts.fujitsu.com
for the Japanese
269.
262.
"Performing a RAID
111.
273