Figure 306: Installing the RAID card holder
Ê Place the controller on the mounting tabs on the slot bracket (1).
Ê Secure the slot bracket to the controller with two M3 x 4.5 mm screws (2).
9.5.1.4
Installing the SAS RAID controller
Ê Remove the SAS RAID controller from its protective packaging.
I
For further instructions regarding controller settings, please refer to
the accompanying documentation.
Ê If applicable, attach the required slot bracket to the expansion card as
described in section
TX300 S7 / RX350 S7
"Preparing the SAS RAID controller" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
476.
477