Installing Accessible Drive Dummy Covers; Installing The 4X 3.5-Inch Hdd Extension Box; Concluding Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

12.7.2.5 Installing accessible drive dummy covers

I
if the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
the following description does not apply. Please proceed as described in
section "Installing the 4x 3.5-inch HDD extension box" on page
Installing accessible drive filler covers
Ê Install accessible drive filler covers (C26361-K644-C933) into the empty
installation bays 1, 2 and 3 as described in section
drive dummy covers" on page
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Installing accessible drive covers
Ê Install accessible drive covers (C26361-K644-C60) into installation bays 1,
2 and 3 of the front cover as described in section
dummy covers" on page

12.7.2.6 Installing the 4x 3.5-inch HDD extension box

Ê If the 4x 3.5-inch HDD extension box is to be reinstalled in the system,
prepare the accessible drive mounting brackets and install the extension box
into installation bays 1, 2 and 3 as described in section
inch HDD extension box" on page

12.7.2.7 Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
TX300 S7 / RX350 S7
622.
622.
324.
379.
104.
Upgrade and Maintenance Manual
Accessible drives
"Installing accessible
"Installing accessible drive
"Installing the 4x 3.5-
"Installing the system
"Installing the system air duct"
324.
695