16.3
Replacing the intrusion switch cable
Field Replaceable Units (FRU)
Average task duration: 10 minutes
16.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing the intrusion switch cable:
●
– Phillips PH2 / (+) No. 2 screw driver
16.3.2 Preliminary steps
Before removing the intrusion, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
Ê Remove the air duct as described in section
on page
92.
TX300 S7 / RX350 S7
60.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
Cabling
72.
(tower
867