Removing And Preparing The Front Panel Module; Removing The Front Lan Connector - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page

13.2.2.3 Removing and preparing the front panel module

Ê Disconnect the front panel cables from the system board as described in
section "Removing front panel cables from the system board" on page
Ê Remove the front panel module from the chassis as described in section
"Removing the front panel module" on page
Ê Remove the front panel module cover from the front panel frame as
described in section

13.2.2.4 Removing the front LAN connector

Figure 492: Removing the front panel connector
Ê Carefully unlatch the front LAN cable connector from the mounting bracket
(1).
Ê Pull the front LAN cable out through the mounting bracket on the front panel
frame and remove it (2).
TX300 S7 / RX350 S7
378.
"Removing the front panel module cover" on page
Upgrade and Maintenance Manual
Front panel and external connectors
"Removing the system air duct"
705.
"Removing the
702.
708.
731