Installing The 2X 3.5-Inch Hdd Extension Box; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
7.4.2

Installing the 2x 3.5-inch HDD extension box

Upgrade and Repair Units (URU)
Average task duration: 10 minutes
7.4.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the HDD extension box:
●
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
7.4.2.2

Preliminary steps

Before installing the HDD extension box, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 92.
302
133.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
75.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
72.
(tower