Front panel and external connectors
Ê Remove the air duct as described in section
on page
92.
Ê Remove the system fan holder as described in section
system fan holder" on page
13.2.3.3 Removing the front panel module
Ê Remove the front panel module as described in section
panel module" on page
13.2.3.4 Removing the defective front LAN connector
Ê Remove the defective front LAN connector as described in section
"Removing the front LAN connector" on page
13.2.3.5 Installing the new front LAN connector
Ê Install the new front LAN connector as described in section
front LAN connector" on page
13.2.3.6 Reassembling the front panel module
Ê Mount the front panel module cover on the front panel frame as described in
section
"Mounting the front panel module cover" on page
13.2.3.7 Reinstalling the front panel module
Ê Reinstall the front panel module as described in section
panel module" on page
13.2.3.8 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page
94.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page
734
378.
702.
720.
711.
379.
104.
Upgrade and Maintenance Manual
"Removing the system air duct"
"Removing the
"Removing the front
730.
"Installing the
709.
"Installing the front
"Installing the system
"Installing the system air duct"
TX300 S7 / RX350 S7