Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 249

Ê Install HDD / SSD modules or HDD dummy modules into the additional HDD
slots as described in sections
page 208 and
page 214.
I
For detailed information on HDD mounting order, refer to section
inch HDD / SSD configurations" on page
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
BitLocker functionality" on page
TX300 S7 / RX350 S7
"Installing a 2.5-inch HDD / SSD module" on
"Installing a 2.5-inch HDD / SSD dummy module" on
"Mounting the side cover" on page 114
125.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
191.
122.
"Connecting the server to
156.
"Mounting the top cover"
124.
"Enabling
"2.5-
(tower
249