Removing The Multibay Box; Removing The Slimline Odd From The Multibay Box; Removing The Lsd Module From The Multibay Box; Installing The Slimline Odd Into The Multibay Box - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page
I
Removing the front cover is not required in order to replace the slimline
ODD or LSP in the Multibay box.

12.5.3.3 Removing the Multibay box

Ê Remove all cables from the slimline ODD.
Ê Remove the LSD cable from system board connector SMB 1.
Ê Remove the Multibay box from the server as described in section
the Multibay box" on page

12.5.3.4 Removing the slimline ODD from the Multibay box

Ê Remove the defective slimline ODD from the Multibay box as described in
section "Removing the slimline ODD from the Multibay box" on page

12.5.3.5 Removing the LSD module from the Multibay box

Ê Remove the defective LSD module from the Multibay box as described in
section "Removing the LSD module from the Multibay box" on page

12.5.3.6 Installing the slimline ODD into the Multibay box

Ê Install the new the slimline ODD into the Multibay box as described in section
"Installing the slimline ODD into the Multibay box" on page

12.5.3.7 Installing the LSD module into the Multibay box

Ê Install the new LSD module into the Multibay box as described in section
"Installing the LSD module into the Multibay box" on page

12.5.3.8 Installing the Multibay box

Ê Reinstall the Multibay box as described in section
box" on page 635.
654
378.
654.
Upgrade and Maintenance Manual
"Removing the system air duct"
"Removing the
654.
633.
"Installing the Multibay
TX300 S7 / RX350 S7
"Removing
647.
649.