Installing The Tpm Board - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

System board and components
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
Ê Remove the air duct as described in section
on page 92.

14.3.1.3 Installing the TPM board

Figure 514: TPM kit
TPM kit (S26361-F3299-E2):
1 TPM module
S26361-D2727-A10
2 TPM spacers
I
Use the white TPM spacer (A3C40106008).
The black TPM spacer is not used in this server.
3 TPM special screw
C26192-Y10-C176
4 TPM bit insert for TPM special screw
774
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
TX300 S7 / RX350 S7
72.
(tower