Removing And Preparing The Front Panel Module; Removing The Vga Connector - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page
Ê Remove the air duct as described in section
on page 92.
Ê Remove the system fan holder as described in section
system fan holder" on page

13.3.2.3 Removing and preparing the front panel module

Ê Disconnect the front panel cables from the system board as described in
section "Removing front panel cables from the system board" on page
Ê Remove the front panel module from the chassis as described in section
"Removing the front panel module" on page
Ê Remove the front panel module cover from the front panel frame as
described in section

13.3.2.4 Removing the VGA connector

Figure 501: Removing the front panel connector
Ê Remove the two hexagon bolts from the front VGA connector (1, see close-
up).
TX300 S7 / RX350 S7
75.
378.
"Removing the front panel module cover" on page
Upgrade and Maintenance Manual
Front panel and external connectors
"Removing the system air duct"
705.
"Removing the
702.
708.
747