Main memory
10.3
Removing memory modules
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
10.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing memory modules: tool-less
●
10.3.2 Preliminary steps
Before removing a memory module, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the defective server as described in section
server" on page
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Bring the server to its horizontal position.
542
133.
60.
67.
68.
"Extending the server out of the rack" on page
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
134.
"Locating the defective
"Shutting down the
"Disconnecting the server
73.
TX300 S7 / RX350 S7
72.