Replacing The Slimline Odd; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Accessible drives
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page

12.7.3 Replacing the slimline ODD

Upgrade and Repair Units (URU)
Average task duration: 10 minutes

12.7.3.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing a slimline ODD:
●
– Phillips PH2 / (+) No. 2 screw driver
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)

12.7.3.2 Preliminary steps

Before replacing a slimline ODD, perform the following steps:
Ê Locate the desired server as described in section
server" on page
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page 136.
696
"Mounting the side cover" on page 114
125.
60.
"Removing backup and optical disk media" on
Upgrade and Maintenance Manual
"Mounting the top cover"
124.
122.
"Connecting the server to
"Locating the defective
TX300 S7 / RX350 S7
(tower