Figure 316: Connecting the BBU cable to the controller
Ê For easier access to the BBU connector, temporarily remove the SAS RAID
controller from its slot as described in sections
controller" on page 481
Ê Connect the loose end of the BBU cable to the RAID controller.
V
CAUTION!
Make sure that the connector side with the three dots points towards
you. Otherwise, short-circuits may result!
Ê Reinstall the SAS RAID controller as described in sections
SAS RAID controller" on page 475
page
401.
TX300 S7 / RX350 S7
or
"Removing expansion cards" on page
or
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing the SAS RAID
"Installing expansion cards" on
410.
"Installing the
493