Installing The 8X 2.5-Inch Hdd Extension Box; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
7.4.8

Installing the 8x 2.5-inch HDD extension box

Upgrade and Repair Units (URU)
Average task duration: 10 minutes
7.4.8.1

Required tools

Preliminary and concluding steps: tool-less
●
Installing the HDD extension box:
●
- Slotted screw driver (for bending in or out accessible drive mounting
brackets)
7.4.8.2

Preliminary steps

Before installing the HDD extension box, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Shut down the server as described in section
page 67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
TX300 S7 / RX350 S7
125.
133.
68.
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
124.
122.
"Connecting the server to
"Disabling BitLocker
"Shutting down the server" on
"Disconnecting the server
339