Concluding Steps; Removing Rear Fan Modules; Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

8.3.1.4

Concluding steps

Perform the following procedures to complete the task:
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
8.3.2

Removing rear fan modules

Customer Replaceable Units (CRU)
Average task duration: 5 minutes
8.3.2.1

Required tools

Preliminary and concluding steps: tool-less
●
Replacing the fan module: tool-less
●
8.3.2.2

Preliminary steps

Before removing a rear fan module, perform the following steps:
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75 (rack server) or
server).
TX300 S7 / RX350 S7
"Mounting the side cover" on page 114
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
"Mounting the top cover"
124.
122.
73.
"Removing the top cover"
Fans
(tower
72.
(tower
385