Installing A Processor - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

11.2.3 Installing a processor

I
This description applies to the following procedures:
– Installing the second CPU in a mono-processor configuration
– Transferring a CPU after replacing the system board (see section
"Swapping processors" on page
Figure 351: Opening socket release lever 1
Ê Unlatch the socket release lever marked Open 1st by pushing it down and
away from the socket (1).
Ê The socket release lever will slightly lift up (2).
TX300 S7 / RX350 S7
Upgrade and Maintenance Manual
807)
Processors
553