Concluding Steps; Removing An Fbu - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Expansion cards and backup units
9.6.4.4

Concluding steps

Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section
fan holder" on page
Ê Reinstall the air duct as described in section
on page 94.
Ê Close the side / top cover as described in section
on page 107 (rack server) or
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section
the mains" on page
9.6.5

Removing an FBU

Upgrade and Repair Units (URU)
Average task duration: 5 minutes
V
CAUTION!
Do not throw battery backup units into the trash can. Batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section
protection" on page
508
379.
"Mounting the side cover" on page 114
125.
56.
Upgrade and Maintenance Manual
"Installing the system
"Installing the system air duct"
"Mounting the top cover"
124.
122.
"Connecting the server to
"Environmental
TX300 S7 / RX350 S7
(tower