Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual page 818

Table of Contents

Advertisement

System board and components
Figure 546: Connecting cables to the system board (C)
Ê Run the SAS and intrusion switch cables through the cable clamps (C) on
the HDD cage and the cable guide (G) as shown.
Ê Connect the SAS cable (if applicable for your configuration) and intrusion
switch cable to the system board.
I
For further information on SAS backup drive cabling, refer to section
"SAS backup drive (LTO3)" on page
Cable
No.
(T26139-)
Intrusion switch
6
cable
Y3922-V121
SAS cable (4x 3.5"
HDD configurations
7
only) or SAS backup
drive cable
1
Requires installed Onboard SAS enabling key (see section
enabling key" on page
818
Cabling
from
list no.
Intrusion switch
13
holder
15-18
Power backplane
7
connector X25
788)
Upgrade and Maintenance Manual
613.
to
System board
connector
INTRUSION
System board
connector
1
SAS 1-4
"Installing the onboard SAS
TX300 S7 / RX350 S7
Cabling
plan
16.2.1
16.2.1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Primergy tx350 s7

Table of Contents