Removing The Intrusion Switch Cable - Fujitsu PRIMERGY TX300 S7 Upgrade And Maintenance Manual

Hide thumbs Also See for PRIMERGY TX300 S7:

Table of Contents

Ê Remove the system fan holder as described in section

system fan holder" on page

16.3.3 Removing the intrusion switch cable

Figure 587: Disconnecting the intrusion switch cable

Ê Disconnect the intrusion switch cable from the system board.

Ê Remove the intrusion switch cable from the cable guide (G) and the two

cable clamps (C) on the HDD cage.

Upgrade and Maintenance Manual

"Removing the

TX300 S7 / RX350 S7

Primergy tx350 s7