12.6.1.5 Removing accessible drive dummy covers
Removing accessible drive filler covers
Ê Remove accessible drive filler covers from installation bays 2 and 3 as
described in section
V
CAUTION!
Always replace filler covers into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
Removing accessible drive covers
Ê Remove accessible drive covers from installation bays 2 and 3 as described
in section
"Removing accessible drive covers" on page
12.6.1.6 Installing the 2x 3.5-inch HDD extension box
Ê Prepare the accessible drive mounting brackets and install the 2x 3.5-inch
HDD extension box into installation bays 2 and 3 as described in section
"Installing the 2x 3.5-inch HDD extension box" on page
12.6.1.7 Cabling the slimline ODD and LSD
I
For SAS cabling of HDD extension box backplanes, please refer to
section
"HDD extension boxes" on page
The cabling list number and cabling plan sections in the allocation tables
below refer to chapter
Slimline SATA ODD
Cable
(T26139-)
SATA cable
Y3958-V205
Slimline ODD SATA
power cable
Y3986-V302
TX300 S7 / RX350 S7
"Removing accessible drive filler covers" on page
"Cabling" on page
Cabling
from
list no.
20
Slimline ODD
Slimline ODD
8
(15-pin SATA)
Upgrade and Maintenance Manual
Accessible drives
603.
305.
299.
849.
to
System board
connector SATA 1
3.5-inch HDD
backplane 2
connector X9
(4-pin connector)
602.
Cabling
plan
16.2.1
16.2.5
665