14.3.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing the system board:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the TPM:
●
– Bit screw driver
– TPM bit insert
– thin slotted screw driver (2 x 0.4 mm)
(
)
*
For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)
14.3.3.2 Preliminary steps
Before replacing the TPM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Locate the desired server as described in section
server" on page
Ê Shut down the server as described in section
page
67.
Ê Remove the AC power cords from the PSU cable brackets and disconnect
them from the system as described in section
from the mains" on page
Ê When working on a rack-mounted server, extend it out of the rack as
described in section
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page
Ê Open the side / top cover as described in section
on page 75
(rack server) or
server).
Ê Remove the air duct as described in section
on page
92.
TX300 S7 / RX350 S7
(
)
*
133.
60.
68.
"Extending the server out of the rack" on page
"Removing the side cover" on page 84
Upgrade and Maintenance Manual
System board and components
(
)
*
"Disabling BitLocker
"Locating the defective
"Shutting down the server" on
"Disconnecting the server
73.
"Removing the top cover"
"Removing the system air duct"
72.
(tower
785