Greasing And Additions; Motor Oil; Motor Oil Change; Gearbox Oil - SELVA MARINE Oyster 5 Owner's Manual

Greasing and additions

Motor Oil

This engine is equipped with a forced lubrification system on the
head block.
Selva deliver the engine with the oil sum empty
Please pay the maximum attention before to start the
engine that the oil sum will be filled with the specific oil and in
the specific quantity as indicated in the technical table
The user has to change the oil completely after the first 10 cruising
hours.
After this change the level has to be checked every 50 hours using
the appropriate graded deapstick, which is insterted in the level plug,
and replace it every 100 hours anyway at least once per season.

Motor oil change

To change the Motor oil do as follow:
Keep the motor in vertical position.
Place a container to collect the used oil under the drain-oil hole
Take out the oil-level plug and the oil drain-plug.
Wait until the oil has drained completely, (during this operation you
must check, if water or other foreign bodies are to be found in the
drained oil. They are signs of anomalies which must be identified
and repaired by qualified staff, before using the motor again).
Insert the oil drain plug and check the seal.
Throught the filling hole fill the oil.
The oil must agree with the characteristics listed in the
greasing chart, and must comply with the quantity pointed
out in the technical detailed list.
Insert and tighten the oil-level plug and the oil drain plug.
Gearbox-oil
Selva supply the motor already with the oil in the gearbox, which the
user will have to change completely after the first 20 cruising hours
After this change you must check its level every 50 hours and
change it every 100 hours, and anyway each season.

Gearbox-oil change

To change the oil do as follows:
Keep the motor in vertical position.
Place a container to collect the used oil under the gearbox.
Take out the oil-level plug and the oil drain-plug.
They have a different size and after the oil change they
must be replaced in their proper seat.
Wait until the oil has drained completely, (during this operation you
must check, if water or other foreign bodies are to be found in the
drained oil. They are signs of anomalies which must be identified
and repaired by qualified staff, before using the motor again).
Protecting the leaning parts, put the motor horizontally, with the oil-
level plug and the oil drain-plug holes upwards.
Inject the oil into the oil drain-plug hole.
The oil must agree with the characteristics listed in the
greasing chart, and must comply with the quantity pointed out in the
technical detailed list.
Insert and tighten the oil-level plug and the oil drain plug.
Picture No. 58.
21
Picture No. 57.