Disassembling The Cylinder Block - SELVA MARINE Dorado 50 EFI Service Manual

Disassembling the cylinder block

1. Remove the thermostat
exhaust cover by removing the bolts in
the sequence shown.
2. Remove the oil filter.
NOTE:
Be sure to clean up any oil spills.
Oil filter wrench: 90890-01426
3. Remove the crankcase bolts in the
sequence shown.
6C13G11
4. Remove the connecting rod bolts and the
cover and
S6C15620
5. Remove the connecting rod and piston
6. Remove the piston pin clips 1 and pis-
NOTE:
• Be sure to keep the bearings in the order as
they were removed.
• Mark each piston with an identification
number a of the corresponding cylinder.
• Do not mix the connecting rods and caps.
Keep them organized in their proper
groups.
connecting rod caps, and then remove
the crankshaft and oil seals.
assemblies.
ton pin, and then remove the piston.
Cylinder block
1
2
3
4
S6C15890
5
6
7
8
9
5-38