Kyocera 300ci Service Manual page 73

Maintenance
item No.
Adjusting the print start timing
U034
Description
Adjusts the leading edge registration or center line.
Purpose
Make the adjustment if there is a regular error between the leading edges of the copy image and original.
Make the adjustment if there is a regular error between the center lines of the copy image and original.
Method
1. Press the start key.
2. Select the item to be adjusted.
Display
LSUOUT TOP
LSUOUT LEFT
LSUOUT TOP B/W*
*: 50/40 ppm model only.
Adjustment: Leading edge registration adjustment
1. Select [LSUOUT TOP] or [LSUOUT TOP B/W].
2. Select the item.
When [LSUOUT TOP] is selected.
Display
LSUOUT TOP
MPT (L)
LSUOUT TOP
MPT Half (L)
LSUOUT TOP
CAS (L)
LSUOUT TOP
CAS Half (L)
LSUOUT TOP
DUP (L)
LSUOUT TOP
DUP Half (L)
LSUOUT TOP
MPT (S)
LSUOUT TOP
MPT Half (S)
LSUOUT TOP
CAS (S)
LSUOUT TOP
CAS Half (S)
LSUOUT TOP
DUP (S)
LSUOUT TOP
DUP Half (S)
Large size: 218 mm or more in width of paper.
Description
Description
Leading edge registration adjustment
Center line adjustment
Leading edge registration adjustment in black/white mode
Description
Paper feed from MP tray
(when large size paper is used)
Paper feed from MP tray
(when large size thick paper is used)
Paper feed from cassette
(when large size paper is used)
Paper feed from cassette
(when large size thick paper is used)
Duplex mode (second)
(when large size paper is used)
Duplex mode (second)
(when large size thick paper is used)
Paper feed from MP tray
(when small size paper is used)
Paper feed from MP tray
(when small size thick paper is used)
Paper feed from cassette
(when small size paper is used)
Paper feed from cassette
(when small size thick paper is used)
Duplex mode (second)
(when small size paper is used)
Duplex mode (second)
(when small size thick paper is used)
Setting Default Change in
range setting value per step
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
-3.0 to 3.0 0 0.1 mm
2JZ/2JX/2JV/2H7-5
1-3-27