Kyocera 300ci Service Manual page 175

Maintenance
item No.
Setting: [Permission]
U464
1. Select ON or OFF.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Set Time Interval]
1. Change the setting value using the +/- or numeric keys.
Display
COUNT
2. Press the start key. The value is set.
Setting: [Set Sleep Period for Calib]
1. Change the setting value using the +/- or numeric keys.
Display
Time(min)
2. Press the start key. The value is set.
Setting: [Permission Act.(50sheets)]
1. Select ON or OFF.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Permission (ON/Sleep out)]
1. Select ON or OFF.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The setting is set.
Setting: [Permission (AP/NE)]
1. Select ON or OFF.
Display
ON
OFF
Initial setting: ON
2. Press the start key. The setting is set.
Description
Description
Turns calibration ON
Turns calibration OFF
Description
Setting the interval time of calibration
Description
Setting the standard time of sleep mode
Description
Enables permission to execute at continuously 50 pages
Disables permission to execute at continuously 50 pages
Description
Executes calibration if fuser temperature is less than 50
power-up or recovery from auto sleep mode
Executes calibration regardless of fuser temperature at power-up or
recovery from auto sleep mode
Description
Paper interval calibration at the time of calibration/near end after
toner feed is carried out
Paper interval calibration at the time of calibration/near end after
toner feed is not carried out
2JZ/2JX/2JV/2H7-5
Setting range Initial setting
0 to 9999 (s) 480
Setting range Initial setting
0 to 480 (min) 60

C/122

F at
1-3-129