Kyocera 300ci Service Manual page 174

2JZ/2JX/2JV/2H7-5
Maintenance
item No.
Setting the ID correction operation
U464
Description
Turns ID correction (calibration) on or off. Also, this determines the duration of calibration and the timing of
calibration during printing. Also, this allows individual settings for calibration operation by enabling custom set-
tings.
Purpose
To restrict calibration when poor image quality is generated. Also, this allows individual settings for calibration
by enabling custom settings in setting the calibration cycle under the machine defaults depending on the user
preferences.
Performs AC calibration when replacing the developing or drum unit.
Supplement
If you changes the settings, set the [Set Custom] setting to ON and select [System Menu]  [Adjustment/
Maintenance]  [Color Calibration Cycle]  [Custom].
Method
1. Press the start key.
2. Select the item to be set. The setting screen for the selected item is displayed.
Display
Permission
Set Time Interval
Set Sleep Period for
Calib
Permission
Act.(50sheets)
Permission
(ON/Sleep out)
Permission (AP/NE)
SetCalib Timing
duringPrint
Set Interval
CalibDriveTime
Set Interval
CalibPrint Rate
Set Custom
AC Calibration
Target Value
PrintRate(B/W)
AC Calib
Magnification
SetInt.Calib
PrintRate(H)
Set Calib
TimingduringPrint(H)
AC Calib Type
Warmup Calib Type* Mode setting for start-up calibration
*: 25/25, 30/30 ppm model only
1-3-128
Description
Description
Setting to turn calibration on/off
Setting the interval time of calibration after printing
Setting the standard time for judging whether or not to carry out calibration
based on the sleep time when the machine recovers from the sleep mode.
Turning paper interval calibration on/off after continuously printing 50 pages
Setting execution parameters for calibration when powered up or reverted
from auto-sleep
Paper interval calibration ON/OFF setting at the time of calibration/near end
after toner feed
Setting the standard time for judging whether or not to carry out calibration
based on the continuous print driving time during printing.
Setting the standard time for judging whether or not to carry out paper inter-
val calibration based on the driving time during printing.
Setting the standard printing ratio for judging whether or not to carry out cal-
ibration based on the printing ratio when printing the tenth sheet.
Turning custom settings on/off in setting the calibration cycle under the sys-
tem menu
Executing the AC calibration
Setting the sensor target values for toner thick layer calibration and light
amount calibration
Setting the proportion of black/white printing at which black/white calibra-
tion is executed during color printing.
AC calibration target bias value setting
Setting the standard printing ratio for judging whether or not to carry out cal-
ibration based on the printing ratio when printing the tenth sheet (half
speed).
Setting the standard time for judging whether or not to carry out calibration
based on the continuous print driving time during printing (half speed).
Mode setting for AC calibration bias control