Kyocera 300ci Service Manual page 157

Maintenance
item No.
Setting the size conversion factor
U332
Description
Sets the coefficient of nonstandard sizes in relation to the A4/Letter size. The coefficient set here is used to
convert the black ratio in relation to the A4/Letter size and to display the result in user simulation.
Purpose
To set the coefficient for converting the black ratio for nonstandard sizes in relation to the A4/Letter size.
Setting
1. Press the start key.
2. Change the setting using the +/- or numeric keys.
Display
Calculation Rate
3. Press the start key. The value is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Setting the applied mode
U340
Description
Allocates memory to ensure that there is sufficient memory available for the printer to use as a working area.
Purpose
Modify the memory allocation if insufficient memory for transparency support or XPS direct printing occurs.
Setting
1. Press the start key.
2. Change the setting using the +/- or numeric keys.
Display
Image Memory
Adj.
Image Memory
Adj. Detail
Set the values below in case print failure occurs with the memory shortage. (recommended value)
Image Memory Adj. : +190
Image Memory Adj. Detaile : +1
3. Press the start key. The value is set.
4. Turn the main power switch off and on.
Supplement
The work area for copy is small and it may cause output failure if the values are large.
Description
Description
Size parameter
Description
Area temporarily used to create output
image.
Area temporarily used to hold downloaded
font and other data.
2JZ/2JX/2JV/2H7-6
Setting range Initial setting
0.1 to 3.0 1.0
Setting range Initial setting
0 to 400 (MB) 0
0 to 400 (MB) 0
1-3-111