Kyocera 300ci Service Manual page 167

Maintenance
item No.
When [ALL] is selected, the adjustment of [INPUT], [MTF/GAMMA] and [MATRIX] can be executed at once.
U411
When adjusting, place the three specified originals, and then press the start key.
Set the original 303JX57020, and then place 303JX57010 and 302AC68243 in order on the top of the origi-
nal.
When automatic adjustment has normally completed, [COMPLETE] is displayed. If a problem occurs dur-
ing auto adjustment, [ERROR XX] (XX is replaced by an error code) is displayed and operation stops.
Should this happen, determine the details of the problem and either repeat the procedure from the begin-
ning, or adjust the remaining items manually by running the corresponding maintenance items.
Error Codes
Codes
ERROR 01
ERROR 02
ERROR 03
ERROR 04
ERROR 05
ERROR 06
ERROR 07
ERROR 08
ERROR 09
ERROR 0a
ERROR 0b
ERROR 0c
ERROR 0d
ERROR 0e
ERROR 0f
ERROR 10
ERROR 11
ERROR 12
ERROR 13
ERROR 14
ERROR 15
ERROR 16
ERROR 17
ERROR 18
ERROR 19
ERROR 1a
Completion
Press the stop key. The screen for selecting a maintenance item is displayed.
Description
Black band detection error (scanner leading edge registration)
Black band detection error (scanner center line)
Black band detection error (scanner main scanning direction magnification)
Black band is not detected (scanner leading edge registration)
Black band is not detected (scanner center line)
Black band is not detected (scanner main scanning direction magnification)
Black band is not detected (scanner auxiliary scanning direction magnification)
Black band is not detected (DP main scanning direction magnification far end)
Black band is not detected (DP main scanning direction magnification near end)
Black band is not detected (DP auxiliary scanning direction magnification leading edge)
Black band is not detected (DP auxiliary scanning direction magnification leading edge
Black band is not detected (DP auxiliary scanning direction trailing edge)
Black band is not detected (DP auxiliary scanning direction trailing edge 2)
DMA time out
Auxiliary scanning direction magnification error
Auxiliary scanning direction leading edge detection error
Auxiliary scanning direction trailing edge detection error
Auxiliary scanning direction skew 1.5 error
Maintenance request error
Main scanning direction center line error
Main scanning direction skew 1.5 error
Main scanning direction magnification error
Service call error
DP paper misfeed error
PWB replacement error
Original error
Description
2JZ/2JX/2JV/2H7-5
1-3-121