Kyocera 300ci Service Manual page 109

Maintenance
item No.
Setting the transfer cleaning voltage
U107
Description
Sets the cleaning control voltage for transfer belt unit.
Purpose
Change settings if an offset has occurred due to the failure of cleaning the transfer belt.
Method
1. Press the start key.
2. Select the item to be set.
Display
Belt Clean A(F)
Belt Clean A(H)
Belt Clean B
Belt Clean A(BW)
Setting: [Belt Clean A(F)]
1. Change the value using the +/- or numeric keys.
Display
Width<160
160<=Width<220
220<=Width
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Setting: [Belt Clean A(H)]
1. Change the value using the +/- or numeric keys.
Display
Width<160
160<=Width<220
220<=Width
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Setting: [Belt Clean B]
1. Change the value using the +/- or numeric keys.
Display
Belt Clean B(F)
Belt Clean B(H)
Belt Clean B(BW)
*1: 40/40, 50/40 ppm model *2: 25/25, 30/30 ppm model
2. Press the start key. The value is set.
Description
Description
Transfer belt cleaning voltage (printing)
Transfer belt cleaning voltage (using thick paper)
Transfer belt cleaning voltage (paper interval)
Transfer belt cleaning voltage in black/white mode
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm
wide)
Large sizes (more than 220 mm wide)
Description
Small sizes (under 160 mm wide)
Medium sizes (160 to under 220 mm
wide)
Large sizes (more than 220 mm wide)
Description
Transfer belt cleaning voltage
Transfer belt cleaning voltage (using thick
paper)
Transfer belt cleaning voltage in black and
white mode
2JZ/2JX/2JV/2H7-5
Setting range Initial setting
0 to 255 83 /70
*1 *2
0 to 255 83 /70
*1 *2
0 to 255 83 /70
*1 *2
Setting range Initial setting
0 to 255 62 /50
*1 *2
0 to 255 62 /50
*1 *2
0 to 255 62 /50
*1 *2
Setting range Initial setting
0 to 255 150 /140
*1
0 to 255 120 /105
*1
0 to 255 150
*2
*2
1-3-63