2JZ/2JX/2JV/2H7-5
Maintenance
item No.
Setting: [PUNCH POSITION ADJ]
U246
1. Change the setting value using the +/- or numeric keys.
Description
Adjustment of the paper stop timing
If the distance of the position of a punch hole is smaller than the specified value A, increase the preset
value. If the distance is larger than the value A, decrease the preset value.
2. Press the start key. The value is set.
Setting: [WIDTH F HP ADJ/WIDTH R HP ADJ]
1. Select [WIDTH F HP ADJ] or [WIDTH R HP ADJ].
2. Change the setting value using the +/- or numeric keys.
Description
Adjustment of front side registration home position
Adjustment of rear side registration home position
3. Press the start key. The value is set.
4. Press the stop key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select FINISHER MOTOR, then WID A3 TEST.
The width guides of the Inner tray will move to A3-size position.
6. Pull the Inner tray, insert paper between the guides and check that paper is abut the guides.
7. Repeat the above adjustment until paper is properly in position.
Setting: [STAPLE HP ADJ]
1. Change the setting value using the +/- or numeric keys.
Description
Adjustment of front and back stapling home position -10 to 10
When staple positions are off toward the front side of the machine (sample 1), increase the preset value.
When staple positions are off toward the rear side of the machine (sample 2), decrease the preset value.
2. Press the start key. The value is set.
1-3-98
Description
A
Figure 1-3-17
Sample 1
Figure 1-3-18
Setting
Initial
range
setting
-10 to 10
0
Preset value A: 5.5 + - 2 mm (inch)
9.5 + - 2 mm (metric)
Setting
Initial
range
setting
-10 to 10
0
-10 to 10
0
Setting
Initial
range
setting
0
Sample 2
Change in
value per step
0.487 mm
Change in
value per step
0.314 mm
0.314 mm
Change in
value per step
0.32 mm