Kyocera 300ci Service Manual page 226

2JZ/2JX/2JV/2H7
Section Jam code
Optional 78
DP DP cover open
JAM
79
An original jam in
the original eject
section
Optional 80
finisher Jam between the
finisher and
machine
81
Paper entry sen-
sor non arrival jam
82
Jam in stapler
1-4-8
Conditions
The DP or DP top cover is opened during original
feeding.
When the power is turned on or original feeding
starts, the original feed switch (OFSW), the original
registration switch (ORSW) or DP timing switch 1/2
(DPTSW1/2) turning on.
During single scanning or dual scanning, the original
eject switch (OESW) does not turn on within speci-
fied time of the DP timing switch 1 (DPTSW1) turn-
ing on.
During duplex switchback scanning, the original
eject switch (OESW) does not turn on within speci-
fied time since switchback ejection starts.
During single scanning or dual scanning, the original
eject switch (OESW) does not turn off within speci-
fied time of the DP timing switch 1 (DPTSW1) turn-
ing off.
Paper ejection is not output from the machine to the
document finisher within specified time of the paper
entry sensor (PES) turning on.
The paper entry sensor (PES) turns on before the
eject signal is output from the machine.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned off even
if a specified time has elapsed after the machine
eject signal was received.
(3000-sheet document finisher)
The paper entry sensor (PES) is not turned on even
if a specified time has elapsed after the machine
eject signal was received.
(3000-sheet document finisher)
The paper entry sensor (PES) does not turn off
within specified time of its turning on.
(Document finisher)
The paper entry sensor (PES) is not turned on even
if a specified time has elapsed after the machine
eject signal was received.
(3000-sheet document finisher)
The home position is not detected within the speci-
fied time when driving the staple motor.
(Document finisher)
The staple home position sensor (STSPS) is not
turned on within the specified time when driving the
staple motor (STM).
Specified time
40/40 ppm
25/25 ppm 50/40 ppm
50/40 ppm
30/30 ppm
Color
- - -
- - -
1705 ms 1038 ms 1038 ms
841 ms 512 ms 512 ms
1705 ms 1038 ms 1038 ms
15 s 15 s 15 s
- - -
1613 ms 1152 ms 968 ms
1613 ms 1152 ms 968 ms
3547 ms 2533 ms 2128 ms
1124 ms 803 ms 674 ms
600 ms 600 ms 600 ms
- - -
B/W