Kyocera 300ci Service Manual page 33

Connecting the cassette heater. (metric specifications only)
1. Remove two screws and then remove the
lid.
2. Pull the connector of the cassette heater
wire out from the aperture.
3. Connect the jumper connector to the con-
nector of the cassette heater wire.
4. Seat the cassette heater wire into the
machine inside.
5. Refit the lid.
6. Run maintenance item U327 and select
"MODE Setting" and set "MODE2".
Lid
Screws
Connecting the power cord.
1. Connect the power cord to the power cord connector on lower left of the machine.
2. Connect the power plug to the wall outlet.
Connector
Jumper connector
Connector
Figure 1-2-15
2JZ/2JX/2JV/2H7-5
Cassette
heater wire
Aperture
Cassette
heater wire
1-2-11