Kyocera 300ci Service Manual page 28

2JZ/2JX/2JV/2H7
Removing the eject spacer and silica gel.
1. Remove the eject spacer and silica gel from
the eject section.
Removing the tapes.
1. Remove three tapes.
Installing the paper feeder (option).
1. Install the optional paper feeder as necessary.
2. Verify levelness at the four corners of the contact glass using a level gauge, and adjust the
level bolts at the bottom of the machine to optimize levelness.
1-2-6
Silica gel
Eject spacer
Figure 1-2-6
Tape
Figure 1-2-7
Tape
Tape