Pulley Alignment - BOMBARDIER 1982 Shop Manual

SECTION 03 TRANSMISSION
SUB-SECTION 04 (DRIVEN PULLEY)
DRIVEN PULLEY REMOVAL
Remove the following items:
- pulley guard and drive belt
-@ @ Support screws and drive axle housing screws
- @
Tilt support forward.
- remove the driven pulley assembly from the counter-
shaft.
DISASSEMBLY AND ASSEMBLY
+
WARNING: The driven pulley cam is spring load-
ed. Hold in place when removing the circlip .
....... 1.
.
.
. '
Check sliding half bushing wear, replace bushing if wear
is excessive.
To replace bushing, push out using a press.
Install new bushing using same procedure.
Q
~
c~
Check tension using a fish scale positioned at 90° with
the pulley axle.
Citation 4500, Nordik, Skandic, Futura 300:
51/2 kg
~
1 (12 Ibs
~
2)
All other Citation and Mirage: 3.6 kg -:- 1 (8 Ibs
""!:
2).
To correct spring tension displace spring end according-
ly .
~
INSTALLATION
®
Torque to 9 N.m (6 ft-Ibs).
@
Always apply anti-seize compound (Loctite anti-seize
lubricant PIN 413 7010 00) on unpainted surface of
cou ntershaft.
@Torque to 30 N.m (22 ft-Ibs) .
@
Make sure the lock tab is properly folded over each
nut.
Reassemble driven pulley to countershaft and install by
inversing the removal procedure.
Check pulley alignment .