BOMBARDIER 1982 Shop Manual page 285

( '
SECTION 03 TRANSMISSION
SUB-SECTION 08 (GEARBOX)
--'-------------------------------------------------------------------------------------------------
From the left side of vehicle, place the drive axle within
the track. Push the end bearing side of axle through the
orifice in left side of frame, then push the splined end of
axle into gearbox lower sprocket. Install opposite drive
axle.
Press each end bearing housing into frame and over axle
bearing. Secure housings to frame.
Install seals.
O
NOTE: A gap of approximately 1.6 mm
(1/16")
should exist between the end of bearing housing
and seal.
Install rear axle and bogie wheel sets to their original po-
sition.
Rotate the tensioner axle
®
to obtain 6 mm
(1/4")
maxi-
mum drive chain free-play.
Fill gearbox with 450 ml (16 Imp. ounces) of Bombardier
chaincase oil.
Install exhaust manifold, drive belt and brake assembly .
Proceed with pulley alignment.
Proceed with track tension and alignment.
Reinstall the hood.
r.'i~;----------------T------------r~------------
PAGE 285