BOMBARDIER 1982 Shop Manual page 219

c
• I'
Lift the countershaft upward approx. 50 mm (2 in.)
and slip the belt between the shaft and the bearing
cage to remove completely .
O
NOTE: It may be necessary to loosen the brake
adjustment in order to easily lift the countershaft.
- Slip the belt out from the drive pulley.
•
WARNING: After drive belt installation, always
check that the brake disc is correctly installed be-
tween the brake pads and that the brake is well ad-
justed. Check brake light operation.
Brake light
switch
Brake pads
=~f:::M~~J
Brake
disc....;;;;~-#--+l~1
SECTION 03 TRANSMISSION
SUB-SECTION 02 (DRIVE BELT)
- To install the drive belt, reverse the procedure.
_ CAUTION: Once belt is installed, be sure to secure
... the countershaft bearing by closing the bearing cage
and firmly tightening the retaining screw .
• For Elan, Spirit, Futura, Blizzard 5500 MX, Sonic,
Blizzard 9500 and Ultra Sonic, to remove belt from
pulleys and vehicle:
Open the driven pulley by twisting and pushing the
sliding half. Hold in fully open position.
- Slip the belt over the top edge of the sliding half .
Slip the belt out from the drive pulley and remove
completely from the vehicle .
- To install the drive belt reverse procedure.
PAGE217