BOMBARDIER 1982 Shop Manual page 114

SECTION 02 ENGINE
SUB-SECTION 05 (464 ENGINE TYPE)
CLEAN IN G
Clean all metal components in a non-ferrous metal clean-
er.
_ CAUTION : Clean armature and magneto using
. " only a clean cloth.
DISASSEM BL Y
• To gain access to magneto assembly, remove :
- rewind starter
- starting pulley
@
O
NOTE: Before disassembling magneto plate, in-
dexing marks should be located to facil itate re-as-
sembly .
• @
To remove magneto flywheel retaining nut:
lock crankshaft with crankshaft locking tool (service
tool) as illustrated (magneto side piston must be at
top dead center)
remove magneto retaining nut
O
NOTE: It should be noted that to correctly remove
a "Loctite" locked fastener it is first necessary to
tap on the fastener to break "Loctite" bond. This will
eliminate the possibility of thread breakage.
PA GE 11 2
• @)
To remove magneto housing (flywheel) :
lock crankshaft w ith crankshaft locking tool (service
tool) as illustrated
adjust magneto housing puller and puller ring as il-
lustrated
r - - - - -- - -- ,
I
e§
Magneto housing
puller and ring
tighten puller bolt and at same time, tap on bolt
head using a hammer to release magneto from its
taper .
REPAIR
• G)
To replace generating coil:
Heat the armature plate around the screw holes to
break the Loctite bond (200° F)
Protect harness
from flame
~ CAUTION: Protect harness from flame.
Remove screws (use Phillips no. 2 or suitable flat
sc rew driver)
Cut the four wi res as close as possible to the coil
body